S2K Commerce - Products Dropdown
S2K Commerce - Shopping Cart
S2K Commerce - Order Entry
EXRAD Can-Bus Cable
Marinco On-board Battery Chargers
GEP Power Distribution Modules
Distribution Module, Pre-populated, 300A
  • Littelfuse FLEC3000Z-0 Configurable Power Distribution Module
  • Category: Power Distribution Modules
  • Manufacturer: Littelfuse
  • Volt Rating: 12 or 24V DC
  • Max Load: 300A
  • Max Fuse Rating: 30A
  • Fuse Capacity: 28 MINI style
  • Relay Capacity: 18 ISO style
  • Operating Temp: -40 to +85C
  • Vibration Resistance: ISO 16750-3 Test II, 32 Hours
  • Shock Resistance: ISO 16750-3, Section 4.2.2
  • Output Connectors: Delphi GT Series
  • FLEC maximizes available space and limits the number of additional units required
  • The versatile nature of the FLEC unit means it can accept a large number of component types. MINI, ATO, MAXI, JCASE, MCASE, and ISO components are all accepted
  • Rugged and sealed, the unit boasts an IP67 rating which allows it to be mounted in locations susceptible to moisture and dirt without any adverse effects
  • Input stud caps prevent accidental short circuit while performing maintenance to and around the box
  • Reduced risk of wiring faults: the FLEC uses highly reliable printed circuit board
  • Note: FLEC can be custom designed. Contact Waytek sales for details
  • FLEC parts included:
    • 6 - 15A MINI Fuse
    • 22 - 30A MINI Fuse
    • 18 - ISO 280 Micro Relay with Resistor
      • NO Amp: 35A
      • NC Amp: 20A
      • Volt Rating: 12V
    • 2 - Spare 15A MINI Fuse
    • 2 - Spare 30A MINI Fuse
    • 1 - Fuse Puller
  • Power Distribution Connectors Correspond with below parts:
    • J4 Connection - GT280 14-way 38391
    • J5 Connection - GT150 16-way 38337
    • J6 Connection - GT150 10-way 38333
    • J7 Connection - GT150 12-way 38335
    • J8 Connection - GT280  8-way  38382
    • J9 Connection - GT280 16-way 38388
346.5000
EACH
This function is not yet complete
Throttle, 12V signal activated
An ideal solution for a range of operating conditions where more power is needed to operate air conditioning, mobility lifts, air compressors, work lights and other auxiliary equipment, while maintaining engine speed at prescribed levels.
  • InPower DBT-LD-02 Light Duty Vehicle Data Bus Throttle
  • Category: Solid State Relays
  • Manufacturer: Inpower
  • DBT's plug-and-play design eliminates the need for Stationary Elevated Idle Control (SEIC) wires in the installation. Instead, just plug it into the OBD-II port and go. T cabling leaves the vehicle's on-board diagnostic system open for a technician's use
  • InPower's DBT-LD Data Bus Throttle provides high idle engine RPM control for light-duty vehicles. It features a plug-and-play design for fast and easy installation. The control module connects to the vehicle's OBD-II diagnostic connector via a cable that includes a second OBD-II connector for any other necessary OBD-II access. The cable also includes blunt-cut wires for the operating mode inputs, the PTO output signal, and the speed adjustment
  • InPower's fast idle electronic throttles provide elevated engine idle speed when the vehicle is stationary. This increased speed provides higher power levels for heavy alternator loads, air conditioner systems, and power take-off (PTO) applications. InPower's throttles are fully interlocked to ensure safe operation in an elevated idle mode. Individually adjustable speed presets allow different speeds for multiple applications, such as air compressors or aerial lifts. A data link to the engine controller ensures precise speed control, interlocking, and operation of the diagnostic LED indicators 
  • Supports Ford and Chevy light-duty vehicles
  • Low cost with fast and easy installation
  • Automatic charge protection and fixed speed modes
  • Data bus cable connects to OBD-II connector
  • No Ford SEIC wiring required
  • LED status and diagnostic indicators
  • Extra OBD-II connector in data bus cable
  • 12 Volts: Sourced from OBD-II Connector
  • Ground: Sourced from OBD-II Connector
  • PTO Output: +12 volts @ 3 amps. Set when module is activated
  • Speed Adjust Input: Adjusts preset RPM to desired value between 900 and 2000 RPM
90.3400
EACH
This function is not yet complete
Relay, Parallel and Series Resistor
  • TE Connectivity V23132-A2001-B200 Power Relay, Parallel and Series Resistor 
  • Category: Mechanical Relays & Connectors
  • Manufacturer: TE Connectivity
  • Typical applications: engine control, glow plug, diesel engines & switches for loading ramps, start/stop 
  • High current automotive relay
  • Limiting continuous current 130A at 85* C
  • Circuitry: SPST - NO
  • Two terminals with parallel and series resistor
  • Coil Termination: Screw
  • Mating 2-pole Connector: Amp Superseal 1.5 Series #38280
  • Coil Type: Non-Latching
  • Rated Voltage Coil: 12/24VDC
  • Rated Coil Power: 3.3W
  • Max Coil Temperature: 155* C
  • Contact Arrangement: 1 form A, 1 NO
  • Immersion: IP67
  • Screw Terminal: M6
64.5000
EACH
This function is not yet complete
  • Molex 63811-1000 Hand Crimping Tools
  • Category: MLX Connectors
  • Manufacturer: Molex
  • Component Type: Crimper Tool
  • Gauge: 24-14 AWG
  • Service grade
  • Ideal for field repair and prototyping
  • Ergonomic soft grip handles for comfortable crimping with small handle spread
42.6000
EACH
This function is not yet complete
Fuse Block, Independent Source
Packaged for retail use only. For bulk product, see item 78262B (must be logged in to purchase bulk)

A compact solution to circuit protection that gives an easy and economical solution for satisfying the *ABYC 7" circuit protection rule. This version is for three independent circuits. There is another version of this available for three circuits with a common power supply.
  • Blue Sea Systems 5194 MRBF Surface Mount Fuse Block
  • Category: Fuse Holders
  • Manufacturer: Blue Sea Systems
  • Safely holds three MRBF fuses supplied from a single power source
  • Provides high current protection for the tightest space constraints
  • Versatile wiring options allow all wires to come out a single side
  • Meets J1171 ignition protection requirements when cover is securely latched
  • Fused sold separately 
  • Maximum Amperage: 300A per block, 240A per circuit
  • Maximum Voltage: 58V DC
  • Mounting: Surface Mount M5 (#10)
  • Terminal Stud Size: M8 (5/16"-18)
*Mounting Placement Dimensions for a Fuse or Circuit Breaker (7" / 40" / 72" ABYC Rule): 
  • 7 inch maximum if the conductor is not housed in a sheath or enclosure in addition to the wire insulation
  • 40 inch maximum if the conductor is housed in a sheath or enclosure in addition to the wire insulation
  • 72 inch maximum if the conductor is connected directly to the battery and housed in a sheath or enclosure in addition to the wire insulation  
59.9000
EACH
This function is not yet complete
Switch, Double Pole, DPDT, On-Off-On, 16A, 12/24V
  • Carling Technologies STJ2E1-53 Sealed Metal Toggle Switch
  • Category: Toggle Switches
  • Manufacturer: Carling Technologies
  • Rating: 16A
  • Suitable for low voltage 12/24VDC
  • Circuitry: DPDT
  • Contact Action: On-Off-On
  • Contact Type: (6) 1/4" Blades
  • Dielectric Strength: 1000V
  • Mechanical Life: 150,000 cycles
  • Operating Temperature: -40C to +85C
  • Comply with ML-DTL-3950G Requirements
  • IEC 60529 IP68 Sealing Performance
  • Complies with UL 61058-1
  • Typical applications: Off-Highway Vehicles, Military Equipment, Armored Vehicles, Law Enforcement Vehicles
22.5100
EACH
This function is not yet complete
Qty Item #
get a quote
Online Quotes looking for pricing on quantities larger than what's listed? Request a large quantity quote.