Z6_EL9QHKG10GPM20IJGE61AK10O0
Z7_P86CH0O0I0RF10IB06HRVQ0087
Z7_11LI04820H5B40QDV9TVRM1002
Z7_EL9QHKG10GPM20IJGE61AK10S5
Disconnect Switch, 100A, 12V
InPower's Model LVD20 Series Low Voltage Disconnects (LVD) automatically disconnects 12 volt loads from the battery when the battery voltage drops below a critical level, leaving enough charge for the vehicle to be restarted. When positive voltage is applied to the control terminal, the disconnect switch turns on, applying battery voltage to its load output. When the disconnect switch is on, its controller monitors the battery voltage at its battery terminal.
- InPower LVD20-100-SPC442 Low Voltage Disconnect Switch
- Category: Low Voltage Disconnects
- Manufacturer: Inpower
- Current Rating: 100A
- Shut-Off Voltage: <11.5 VDC
- Shut-Off Time Period: 60 Seconds
- Control Input Voltage: >9.5 volts to activate; < 8.5 volts to deactivate
- Terminal Size: 3/8-16 Threaded Stainless Steel Studs
- Status LED Indicator for visual status of operation
- Prevents excessive battery discharge by automatically disconnecting loads
- Automatic shutdown protection for short circuit, over current, loss of ground and high temperature
- Sealed construction is resistant to mechanical shock and vibration
114.0100
EACH
This function is not yet complete
13 Circuits w/ Ground, 200A, 12V
- Egis Mobile Electric 8033B Split Buss Fuse Block
- Category: Fuse Blocks
- Manufacturer: EGIS Mobile Electric
- Provides separate isolated groups of fused circuits
- Up to (10) 1-30 Amp Fused Outputs
- Up to (3) 1-50 Amp Fused outputs to support High Amp Loads
- Designed with stainless steel self-locking hardware and optional weather-proof labels in standard options
- Supports SAE Circuit Protection Standards
- Two Un-fused Outputs
- Blown fuse LED indication for each output circuit provides clear indication of faulty circuits and eases trouble-shooting issues remotely.
- Use with 2.8mm blade type fuses
- Insulating cover designed for water and dust proofing
- Maximum Current: 200A Continuous Current / 100 Amp per Input
- Maximum Current Per Circuit: 30A
57.9300
EACH
This function is not yet complete
22-18 GA, 1/4" Stud, Red Stripe
Sealed Crystal Clear Terminals are designed to provide optimal visual assurance that the termination is installed properly and offers visual inspection of the wire condition over the life of the termination.
- Crystal Clear Heat Shrink Ring Terminal
- Category: Ring Terminals
- 45 degree barrel assures that wire is seated properly and wire is being crimped to terminal
- 45 degree barrel angle allows tubing to adhere to it and provides a stronger seal
- Long ring terminal provides a flush surface for maximum contact & allows ring terminal to be stacked
- Color-coded stripes identify wire gauge size to be used with connector
- Color-coded stripes also indicate/guide where to position crimp nest to install properly
- Brazed seem barrel ensures superior crimp performance
- Serrations in crimp barrel provide strong mechanical termination
- Adhesive lined heat shrink tubing provides optimal clarity for visual inspection
- Ensures a waterproof seal
0.6752
EACH
This function is not yet complete
| Qty | Item # |
