Z6_EL9QHKG10GPM20IJGE61AK10O0
Z7_P86CH0O0I0RF10IB06HRVQ0087
Z7_11LI04820H5B40QDV9TVRM1002
Z7_EL9QHKG10GPM20IJGE61AK10S5
InPower DBT-LD-01 Light Duty Vehicle Data Bus Throttle, Ground signal activated
Item #: 85551
Manufacturer Item: DBT-LD-01
Manufacturer:
InPower
Min. Order Qty: 1
Available: 2
99.6100
EACH
Quantity:

Quantity | Ea. Price | Ext. Price |
1 | 99.6100 | 99.61 |
5 | 95.5800 | 477.90 |
10 | 91.7200 | 917.20 |
25 | 83.3800 | 2084.50 |
Made in USA
An ideal solution for a range of operating conditions where more power is needed to operate air conditioning, mobility lifts, air compressors, work lights and other auxiliary equipment, while maintaining engine speed at prescribed levels.
- InPower DBT-LD-01 Light Duty Vehicle Data Bus Throttle
- Category: Solid State Relays
- Manufacturer: InPower
- DBT's plug-and-play design eliminates the need for Stationary Elevated Idle Control (SEIC) wires in the installation. Instead, just plug it into the OBD-II port and go. T cabling leaves the vehicle's on-board diagnostic system open for a technician's use
- InPower's DBT-LD Data Bus Throttle provides high idle engine RPM control for light-duty vehicles. It features a plug-and-play design for fast and easy installation. The control module connects to the vehicle's OBD-II diagnostic connector via a cable that includes a second OBD-II connector for any other necessary OBD-II access. The cable also includes blunt-cut wires for the operating mode inputs, the PTO output signal, and the speed adjustment
- InPower's fast idle electronic throttles provide elevated engine idle speed when the vehicle is stationary. This increased speed provides higher power levels for heavy alternator loads, air conditioner systems, and power take-off (PTO) applications. InPower's throttles are fully interlocked to ensure safe operation in an elevated idle mode. Individually adjustable speed presets allow different speeds for multiple applications, such as air compressors or aerial lifts. A data link to the engine controller ensures precise speed control, interlocking, and operation of the diagnostic LED indicators
- Supports Ford and Chevy light-duty vehicles
- Low cost with fast and easy installation
- Automatic charge protection and fixed speed modes
- Data bus cable connects to OBD-II connector
- No Ford SEIC wiring required
- LED status and diagnostic indicators
- Extra OBD-II connector in data bus cable
- 12 Volts: Sourced from OBD-II Connector
- Ground: Sourced from OBD-II Connector
- PTO Output: +12 volts @ 3 amps. Set when module is activated
- Speed Adjust Input: Adjusts preset RPM to desired value between 900 and 2000 RPM

Solid State Relays
Nominal Voltage
12VDC