Z6_EL9QHKG10GPM20IJGE61AK10O0
Z7_P86CH0O0I0RF10IB06HRVQ0087
Z7_11LI04820H5B40QDV9TVRM1002
Z7_EL9QHKG10GPM20IJGE61AK10S5
Home
>
Power Distribution
>
Power Distribution Modules
> Eaton 31M-000-2 Mulitplex Vehicle Electrical
Eaton 31M-000-2 Mulitplex Vehicle Electrical Center (mVEC), 8 relays, 16 Fuses
Item #: 46066
Manufacturer Item: 31M-000-2
Manufacturer:
Eaton
Min. Order Qty: 1
Available: 0
412.4700
EACH
Quantity:
| Quantity | EA Price | Ext. Price |
| 1 | 412.4700 | 412.47 |
| 5 | 392.8300 | 1964.15 |
| 10 | 374.1300 | 3741.30 |
The mVEC is a power distribution slave module that distributes power to other devices in a vehicle, and communicates over a CAN bus. Because it is a slave module, the mVEC relies on other CAN modules to control its relays and monitor component status messages.
The mVEC is ideal for various applications including heavy truck, construction, agriculture, transit bus and coach, marine, recreational vehicle, and specialty vehicle applications. The mVEC is a cost-effective solution for power distribution systems that require the ability to monitor and control relays and fuses; and a great replacement for complex, fully electronic (solid state) power distribution modules.
The mVEC is ideal for various applications including heavy truck, construction, agriculture, transit bus and coach, marine, recreational vehicle, and specialty vehicle applications. The mVEC is a cost-effective solution for power distribution systems that require the ability to monitor and control relays and fuses; and a great replacement for complex, fully electronic (solid state) power distribution modules.
- Eaton 31M-000-2 Mulitplex Vehicle Electrical Center
- Category: Power Distribution Modules
- Manufacturer: Eaton
- Acts as a slave module on a J1939/CAN network, communicating via the vehicle data bus with the master controller
- Functions as a node in an existing vehicle J1939/CAN multiplexing network
- Controls relays via direction of J1939 CAN bus
- Reports status of relays and fuses each second to the J1939 CAN bus, indicating any blown fuse or failed relay
- Supports both 12VDC and/or 24VDC electrical requirements
- Pre-populated with components that have 2.8mm blades (280-series components) module features:
- (8) - ISO Micro Relay with Resistor
- NO Amp: 35A
- NC Amp: 20A
- Voltage Range: 12-24 VDC
- (16) - 10A Mini/ATM Fuse
- (1) - Fuse Puller
- Output: 8 way power distribution connectors used with tanged terminals
- Input: studded input supports two M8 input power studs for DC power
- CAN connector 38293
- Max Current: 200A
- 100 Per Input Stud (M8)
- 30 Per Output Terminals
- 100A Per Output Connector
- Operating Temperature: 40F (-40C) to 185F (85C)
- Ingress Protection: up to IP66 requirements
- Output Terminals: Delphi Metri-Pack 280 Series (sealed tang or tangless)
WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
Power Distribution Modules
Nominal Voltage
12-24VDC
Ingress Protection
IP66
# of Circuits
16 Circuit
Component Type
mVEC
Current Rating
200A
Temp (Degrees)
-40 to 105 Temp
